Table of Contents
Advertisement
Location of the second RGB Module
The second RGB Module is inserted in the 4th slot of the main frame (Image 1).
image 1
How to remove the second RGB Module.
1. Press the module lock (Image 2)
2. Lift up the module handle (Image 3);
3. Repeat this action on both sides of the module
4. extract the module out of the main frame.
Top view
Top view
Image 2
75 W Termination resistors
In case of chaining (loop-through) the projectors, the 75W line termination resistors must be removed from the second RGB Input
Module when the projector is NOT the last unit in the chain.
In case of a stand-alone projector, do not remove the resistors.
75 W resistors on the module
75 W resistors removed
Removing the termination resistors
1
Turn off the projector and unplug the projector power cord.
2
Remove the top cover from the projector (see Access to ).
3
Remove the RGB Input Module from the main frame.
4
Unsolder and remove the resistors.
Blue in Green Switch
Blue characters are difficult to read, therefore the blue text will be displayed as cyan so that the readability becomes better.
Switch in the ON position
Switch in the OFF position
Warning:
Leaving the switch in the ON position will result in abnormal color balance of the projected image.
Force Negative Sync Switch
Switch in the ON position
Switch in the OFF position
How to select an RGB source:
Select the RGB input by pressing the numeric button 3 on the RCU or the local keypad.
5976195 BARCOCINE 9 31012002
Side view
Side view
Image 3
:
line terminated.
:
line not terminated.
:
Blue in Green active.
:
Blue in Green disabled.
:
the sync pulses must be negative.
:
the sync polarity will be automatically detected.
Source Connections
6-5
Advertisement
Table of Contents
