Table of Contents
Advertisement
Scan position check
To check the scan position i.e. the orientation of the scan connectors proceed as follows:
This procedure can only be done after power (mains) connection. So, first continue with the projector setup and the connections
and then return to this procedure.
1
Switch on the projector. The projector starts up on the last selected source.
2
Press ADJUST.
Highlight SERVICE by pushing the cursor key é or ê (Menu 1).
3
4
Press ENTER: the ' SERVICE MODE MENU ' will be displayed. (Menu 2)
Highlight 'P ROJECTOR SET-UP' by pushing the cursor key é or ê and press ENTER.
5
Push the cursor key é or ê to highlight Identification (Menu 3).
6
7
Press ENTER to select.
The identification screen will be displayed (Menu 4).
This screen gives the current information about the projector configuration in the line entitled ' Config'.
ADJUSTMENT MODE
Select a path from
below :
RANDOM ACCESS
INSTALLATION
SERVICE
source 1
Select with é or ê
then <ENTER>
<EXIT> to return.
Menu 1
All projectors leave the factory set with a ceiling/front configuration.
5976195 BARCOCINE 9 31012002
SERVICE MODE
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
VOLTAGE DIAGNOSTICS
PROJECTOR DIAGNOSTICS
Select with é or ê
then <ENTER>
<EXIT> to return.
Menu 2
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
PROJECTOR WARM UP
POWER UP MODE : operating
COMMON ADDRESS : 0
Select with é or ê
then <ENTER>
<EXIT> to return.
Menu 3
Installation setup
CINE 9
Proj. address : 001
Soft. Version : 6.00
Config. : Ceiling
Front
Baudrate PC : 9600
Text : ON
Serial No. : 103589552
Projector level : 1
Menu 4
4-5
Advertisement
Table of Contents
