Current Weather Mode - DAVIS Vantage Pro2 Console Manual

Note: The baud rate setting on your console must match the serial port setting in the software on your
computer. If you are using WeatherLink for Vantage Pro2, refer to WeatherLink help for instruc-
tions on setting the serial port baud rate on your computer.
1. Press the up and down arrows to select the baud rate.
Your Vantage Pro2 console supports baud rates of 1200, 2400, 4800, 9600,
14400, and 19200.
2. You have completed the console setup. To exit Setup Mode, press and hold
DONE until the current weather screen appears.
Clear All Command
After you have completed the above setup procedures and have exited the
Setup Mode, please use the Clear All command before putting your weather
station into service.
The Clear All command clears all stored high and low weather data including
monthly and yearly highs and lows and clears the alarm settings. The com-
mand is recommended to properly clear and initialize the console's data log-
ging function.
1. Press WIND on the console.
2. Press 2ND, then press and hold CLEAR for at least six seconds.
3. Release CLEAR when you see "CLEARING NOW" displayed at the bot-
tom of the console's screen.

Current Weather Mode

In the Current Weather Mode you can display the current data readings from
your station, select units of measure, and calibrate, set, or clear weather vari-
ables. You can see up to ten weather variables on the screen at the same time,
as well as the time and date, the moon and forecast icons, a forecast or special
message from your station, and a graph of the currently selected variable. A
few variables are always visible on the console screen while most variables
share their location with one or more variables. You can select any variable not
currently on the screen to display it.
Selecting Weather Variables
Select a weather variable to display its data on the screen if it isn't already vis-
ible or to graph the data available for that variable.
Weather variables are selected via the console command keys:
• If the variable is printed on a key, just press the key to select the variable.
• If the variable is printed on the console housing, first press and
release 2ND, then quickly press the key below the variable to
select it.
Current Weather Mode
2 ND
18