Batteries & Memory Cards - Reconyx Hyperfire Manual

Batteries & Memory Cards
Accessing Batteries, Memory Card & Camera Controls
To install the batteries and memory card, your HyperFire
opened using the latch on the right side of the camera. Grasp behind the latch
and flip it toward the front. The camera will open like a book, allowing access to
the batteries, memory card and settings.
Step 1
NOTE: Security cameras come standard in grey – the camouflage housing
is an available option.
Accessing Batteries, Memory Card & Camera Controls
There is a breathable vent underneath the latch of the camera, which will allow
the air pressure inside the camera case to equalize while keeping water out.
NOTE: The breathable vent is vital to keeping the camera weatherproof and
should not be removed or tampered with.
TIP: Each time you open your camera it's good practice to:
 Make sure the gasket is seated properly and is clear of debris.
 Check that the breathable vent underneath the latch has not been
damaged.
 Be sure that the windows on the front of your camera are clean.
 Be sure the latch is fully seated when closing your camera to ensure a
weather-tight seal.
www.reconyx.com
Step 2
camera is easily
TM
Step 3
6