Reconyx Hyperfire Manual page 15

Level 1: Main Menu Items
NOTE: Main Menu Items are shown in Yellow on the Programming
Diagram (Page 13).
Arm Camera – When you select this option, your camera arms in ten seconds,
unless you cancel it before the countdown is complete by pressing the "OK"
button.
WalkTest – When you select this option, your camera flashes an indicator light
so that you can test its aim by walking in front of it. The WalkTest mode shows
you exactly where the camera's active motion detection zones are located. The
tilt of the camera is critical, as slight changes are magnified at greater distances
from the camera.
TIP: If left in WalkTest mode, the camera will automatically arm itself after 2
minutes with no motion events. This allows you to set the camera up, check its
aim using WalkTest, and then just walk away.
Erase Card – When you select this option, your camera wipes your entire
memory card clean, removing all images and other information from the card.
NOTE: You should NOT select Erase Card unless you are absolutely
Check Status – When you select this option, your camera displays the number
of pictures it has taken, the amount of space used on your memory card, and the
amount of battery power remaining.
NOTE: The battery status shows the level for different types of batteries.
Change Setup – Allows you to change the way your camera functions.
Battery Type – Allows you to select what type of batteries you are using to
accurately display the amount of power remaining.
Camera Info – When you select this option, your camera displays its firmware
version number (V) and serial number (S). You may need this information when
contacting RECONYX™ with questions about your camera.
www.reconyx.com
certain you want to remove everything from the card.
If you change battery types be sure to change the "Battery Type"
setting.
14