Reconyx Hyperfire Manual page 10

Secure Digital
A Secure Digital (SD/SDHC) card is used to store the pictures your camera
captures. These images may be transferred to your computer using standard
image viewing software or RECONYX™ MapView™ mapping and image
management software.
TIP: Many digital cameras, GPS units, and cell phones can be used to view
images taken by your HyperFire™ camera. No need to purchase a special
purpose viewer! Keep in mind that many of these devices can only use up to
2GB SD cards.
Inserting and removing the memory card
Make sure the orientation is correct and that the card is aligned properly.
Push gently on the memory card as shown below until it clicks into place.
Warning: Inserting the memory card upside down or backwards could
damage the camera or the memory card. Damage resulting from inserting
the card incorrectly is not covered under warranty.
To remove memory cards:
1. Press <OK> to disarm the camera (the battery status and number of
pictures taken since last armed will be displayed on the LCD).
2. Switch the power OFF.
3. Press and release the card to partially eject the memory card.
4. The card can then be removed by grasping it with your fingers.
NOTE: Always disarm the camera (by pressing OK) and switch the power off
before removing or inserting the memory card.
9
(SD or SDHC) Card Specifications
®
©RECONYX, Inc.