Reconyx Hyperfire Manual page 16

Level 2: Advanced Settings
NOTE: "Advanced Settings" are shown in Grey on the "Programming
Diagram" (Page 13).
Trigger – Turn your camera's motion sensor on or off, select the sensitivity level
of the PIR motion detector, set how many photos you want your camera to take
per trigger, the interval between pictures, and the quiet period (the time period
after a trigger during which the camera will not respond to motion events).
1. Motion Sensor – ON, off
2. Sensitivity - low, low/medium, medium, medium/high, HIGH.
3. Pictures Per Trigger – 1, 2, 3, 5, or 10
4. Picture Interval – RapidFire,
(SM750 defaults to RapidFire)
5. Quiet Period –
Time Lapse – To control your cameras time lapse photography, select the
starting and ending times, and the interval between pictures taken.
1. AM Period – on,
2. PM Period – on,
3. Time Lapse starting and ending times – one hour increments
4. Picture Interval – 1, 2, 3, 5, 15 or 30 seconds
or 1, 5, 15, 30, or 60 minute intervals
(5 second minimum when motion trigger and/or illuminator is on)
Security – Use this option to turn Loop Recording on and OFF. Loop Recording
allows you to run perpetually without ever filling a memory card. The camera will
overwrite the oldest images once the card is full.
NOTE: When Loop Recording is enabled it will prompt to "Erase Card". If
you select "Yes" it will erase all contents on the memory card.
If you select "No" it will disable Loop Recording.
(This prompt will appear every time the camera is powered on.)
NOTE: 2GB or larger cards are recommended when using loop recording.
15
1 SEC, 3 sec, 5 sec, or 10 sec
NO DELAY, 15 sec, 30 sec, 1 min, 3 min or 5 min
OFF
OFF
(SM750 defaults to 5)
©RECONYX, Inc.