Cti Calls - Siemens OpenScape Voice User Manual

Step by step
Settings
User
Configuration
Incoming calls

CTI calls

Auto-answer
Yes
Beep on auto-answer
Yes
Save & Exit
CTI calls
Beep on auto-answer
Speakerphone mode activates automatically on your
phone if you use a CTI application (such as Outlook) to
dial a number when Auto Answer is active. If Auto An-
swer is not active, the phone rings first and you have to
press the loudspeaker key or lift the handset to set up
the call. This setting also defines whether or not incom-
ing calls are automatically accepted. If the function is
active, an alert beep sounds when an incoming call is
automatically accepted.
Information on the operation of the configured CTI ap-
plication can be found in the corresponding user guide.
z You can also configure this setting via the Web interface
! page 198.
Prerequisite: The option was programmed by your ser-
vice personnel.
N
Press the key shown.
Select and confirm the option shown.
Select and confirm the option shown.
j
if nec.
Enter and confirm the User password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Enhanced phone functions
97