Using The Keypad To Configure The E20 - TANDBERG E20 Administrator's Manual

What's in this Guide?

Using the keypad to configure the E20

There are several ways of setting up the E20. This page explains how
to set up the unit using the keypad only, while how to set it up from a
remote PC is explained on the next page.
Press the H key to produce the Home menu and navigate down to
ome
Settings. Press the R
igHt aRRow
navigate down to Advanced. Press the R
Finally navigate down to Advanced configuration and press the R
key again. Navigation like this will hereinafter be shown as
aRRow
Settings > Advanced > Advanced configuration.
1. Navigate to SystemUnit > Name and press oK.
Select a name that is unique to avoid conflicts. We recommend
that you use your name or initials, eg. AliceWonderland. This name
will be seen as you by the others.
2. In most cases DHCP will be used for assignment:
Go to the previous menu—the Advanced (use L
navigate to IP Settings > IP Assignment, if the cursor is not there
already. Press oK and set to DHCP.
Alternatively, set it to Static and enter the IP address, Subnet
Mask and Gateway IP address.
3. For remote administration the below settings are recommended.
This should also make the system visible in TMS.
In the Settings > Advanced > Advanced configuration >
Provisioning > ExternalManager set Address, Protocol, Path,
Domain and Mode, which will be TMS, if used.
4.
To be able to dial, you need to configure the SIP settings.
In the Settings > Advanced > Advanced configuration >
NetworkServices > SIP, set SIP Mode to Off before doing
anything else.
D14330.09 TANDBERG E20 ADMINISTRATOR GUIDE (TE2.1) February 2010
Deploying E20
Introduction Deploying E20
key to produce the Settings menu and
key.
igHt aRRow
key) and
eft aRRow
Using E20
5.
Go to Settings > Advanced > Advanced configuration > SIP >
Profile1. Set Default Transport to Auto (which is the same as default),
Proxy1 Discovery to Manual, You must also enter the IP address of
the Proxy (Proxy is your PBX/VCS or OCS) and you must enter the URI
of your E20. Set the SIP Mode back to On.
6. If your SIP Server/PBX uses user authorization you need to supply
a user-id and password. This is done in Settings > Advanced >
Advanced Configuration > SIP > Profile1 > Authentication 1.
igHt
7. You may want to use a TMS phonebook. If you have this and no entries
are displayed after configuring, you must make sure that your unit is
registered in TMS and a phonebook is assigned to your system.
Your TANDBERG E20 comes with no default administrator
password set. This means that anyone with network access to the
E20 can easily log onto the device with ssh.
We strongly recommend that you set up an administrator password
by using the menu in Settings > Advanced > Change password.
14
The Settings Advanced settings