Using The Assistant To Configure E20 - TANDBERG E20 Administrator's Manual

What's in this Guide?
Deploying the E20
There are four ways of deploying the E20:
• By using the Assistant
• By using the keypad
• By logging into the unit from a remote PC
• By using HTTP Bootstrapping
This page explains how to set up the unit using the Wizard, while the
alternatives are explained on the following pages.

Using the Assistant to configure E20

1. When you start the E20 the first time you will be prompted to choose the
language to be used in the menus and dialog boxes.
2.
Once the language has been selected, the E20 will configure the correct
language and a provisioning assistant will pop up.
3.
The Assistant will help you configure the E20 with the correct parameters.
Observe that TANDBERG has defined a set of DHCP options. The E20 will
pick up these settings if they have been set by your network administrator.
4. The Assistant supports different provisioning or configuration schemes.
TANDBERG VCS (TMS 12.5) is the default scheme and is the only
provisioning scheme fully supported by the E20. The other schemes will
only allow the E20 to be easily configured using a core set of configuration
parameters. You will be prompted to supply username, password, domain,
and external manager address.
D14330.09 TANDBERG E20 ADMINISTRATOR GUIDE (TE2.1) February 2010
Deploying E20
Introduction Deploying E20 Using E20
5.
Once you have completed the fields and selected the register button,
the E20 will contact the external manager and try to provision the device.
You will be notified whether the registration process succeeds or fails.
In case of failure to connect successfully, you may rectify the parameters
and try again or you may choose to cancel the registration process.
6.
Regardless of successful registration or not, the next step of the wizard
will be to adjust the camera. Note that camera adjustment is optional at
this stage—you may choose to do this later.
7.
For the other configuration schemes, you will have to supply username,
password, the SIP proxy and the SIP URI. In all other respects, the Assistant is
similar.
8. HTTP configuration will enable the E20 to download configuration
documents using HTTP/HTTPS.
13
The Settings Advanced settings