Chapter 6
USB Port
EATON Powerware
Communication
The Powerware 9125 UPS is equipped with a USB port, a DB-9
communication port, and an X-Slot communication bay (see Figure 18).
Either the USB port or the DB-9 communication port may be used to
monitor the UPS; however, they cannot operate simultaneously.
The X-Slot communication bay can accommodate any Powerware X-Slot
card and can operate simultaneously with the USB port or DB-9
communication port.
X-Slot Communication Bay
The UPS can communicate with a USB-compliant computer using
t
Powerware LanSafe
To establish communication between the UPS and a computer:
1.
Connect the USB cable to the USB port on the UPS rear panel (see
Figure 18).
Connect the other end of the USB cable to the USB port on your
computer.
2.
Install the Powerware LanSafe software and USB drivers according
to the instructions provided with the Software Suite CD.
®
9125 Two-in-One UPS (5000/6000 VA) User's Guide
USB Port
DB-9 Communication Port
Figure 18. Communication Options
Power Management Software (v5.0.1 or higher).
www.powerware.com
S
164201513 Rev B
37