Chicago Electric 91995 Set Up And Operating Instructions Manual page 9

3. Lock the Saw Blade (56) in its
ward position. To do so, pull out on
the Cross Pin (28). Raise and hold
the Cover Case (89) of the Miter Saw
fully upward. Turn the Cross Pin 90
degrees. Then, insert the Cross Pin
into the deep slot in its locked posi-
tion. (See Figure E.)
FIgURE E
4. CAUTION! The Cross Pin (28)
should always be activated in the
"locked down" position when the
Saw is not being used and when
the Saw is being transported. The
Cross Pin should be activated in
the "locked up" position only when
changing Saw Blades. NEVER use
the Cross Pin in any cutting opera-
tion. The Cross Pin allows the oper-
ator to lock the Saw Blade in position,
preventing the Saw Blade from being
raised or lowered. (See Figure E.)
SKU 91995
up-
CROSS
PIN (28)
For technical questions, please call 1-800-444-3353.
lARgE
COVER
(47)
BOlT
(50)
WRENCH
(110)
FIgURE g
5. Loosen the Screw (48) that holds the
Large Cover (47) in place. Then, use
the Wrench (110) to remove the Bolt
(50). (See Figure g.)
6. Rotate the Large Cover (47) and
Safety Cover (53) up and out of the
way. (See Figure g.)
SPINDlE
lOCk (84)
FIgURE H
7. Depress the Spindle Lock (84) to
keep the Saw Blade (56) from turn-
ing. (See Figure H.)
SCREW (48)
SAFETY
COVER
(53)
Rev 07k
Page 9