Link To Cell Settings; The Handset - Panasonic KX-TG7731C Operating Instructions Manual

Link to cell settings

Selecting which unit receives
cellular calls
You can select which unit rings and receives
calls for a cellular line. When "All" is
selected, all handsets and the base unit ring.
1
MMENUN
2
For CELL 1: #6271
For CELL 2: #6272
3
MbN: Select the desired handset or "All".
4
MSAVEN a MOFFN
Note:
R When you select a specific handset to
receive calls for a cellular line:
– other handsets cannot answer the calls.
– the base unit can answer the calls even
though it does not ring. However, you
can make the base unit ring by adjusting
the base unit ringer volume (page 36).
(KX-TG7741/KX-TG275SK series:
page 3)
R When you change the setting to "All", the
base unit ringer volume also returns to the
lowest level even if the ringer volume has
been changed.
Ring as cell mode
Once this feature is turned on, the handset
and base unit ring using the same ringer tone
as your cellular phone.
The following settings are available:
– "Off": Turn this feature off to use the
ringer tones of the handset and base unit.
Caller information is announced depending
on the Talking Call Display setting
(page 38).
– "On (with Talking CID)"
(default): The handset and base unit use
your cellular phone's ringer tone. Caller
information is announced even if the
Talking Call Display is turned off.
– "On (without Talking CID)": The
handset and base unit use your cellular
phone's ringer tone. Caller information is
TG7731_41C_(en-en)_1207_ver.021.19
not announced even if the Talking Call
Display is turned on.
Important:
R To use this feature, your cellular phone
must support Bluetooth in-band ringtone.
Refer to your cellular phone's operating
instructions.
1
MMENUN
2
For CELL 1: #6141
For CELL 2: #6142
3
MbN: Select the desired setting.
4
MSAVEN a MOFFN
Note:
R The units use the preset ringer tones
(page 38) instead of your cellular phone's
ringer tone when a cellular call is being
received if:
– your cellular phone is in night mode
(depending on your cellular phone).
– the base unit is in use.
– 2 handsets are sharing a landline call.
R If your cellular phone is in night mode with
"On (with Talking CID)" set, the unit
announces caller information even when
Talking Call Display is turned off
(page 38).
To use the handset ringer tone
instead of your cellular phone's
ringer tone
Select "Off" in step 3, "Ring as cell mode",
page 19.
To change the handset ringer tone for a
cellular line, see page 36.
Auto connection to the cellular
phone
After registration, your cellular phone is
connected to the base unit. If you move the
cellular phone out of base unit range, the
cellular phone is disconnected from the base
unit. This feature allows the base unit to try to
reconnect the cellular phone at regular
intervals when it returns within base unit
range. You can set the interval. The default
setting is "1 min".
19
Link to Cell
2011/12/07 19:53:58
19