Remote Operation - Panasonic KX-TG7731C Operating Instructions Manual

– The message indicator on the handset
flashes slowly if the message alert feature
is turned on (page 55).
1
To listen to new messages:
MMENUN#323
To listen to all messages:
MMENUN#324
2
When finished, press MOFFN.
Note:
R To switch to the receiver, press M
Operating the answering system
MMENUN a MbN: "Answering device" a
MSELECTN
Key Operation
MjN or MkN Adjust the receiver/speaker
volume
(during playback)
1 or MFN Repeat message
(during playback)
2 or MEN Skip message
(during playback)
3 Enter the "Settings" menu
4 Play new messages
5 Play all messages
6 Play greeting message
76 Record greeting message
8 Turn answering system on
MPAUSEN
Pause message
9 or Stop recording
MSTOPN Stop playback
0 Turn answering system off
Erase currently playing
*4 *3
message
*5 Erase all messages
*6 Reset to a pre-recorded
greeting message
*1 If pressed within the first 5 seconds of a
message, the previous message is
played.
*2 To resume playback:
TG7731_41C_(en-en)_1207_ver.021.53
Answering System for Landline
MbN: "Playback" a MSELECTN
*3 You can also erase as follows:
MERASEN a MbN: "Yes" a MSELECTN
Calling back (Call Display
subscribers only)
If caller information is received for the call, you
can call the caller back while listening to a
message.
N.
1
Press MPAUSEN during playback.
2
MbN: "Call back" a MSELECTN
Editing the number before calling back
1
Press MPAUSEN during playback.
2
MbN: "Edit & Call" a MSELECTN
3
Press MEDITN repeatedly until the phone
number is shown in the desired format
(page 46). a M
R To call back using a cellular line,
*1
Erasing all messages
1
MMENUN#325
2
MbN: "Yes" a MSELECTN a MOFFN

Remote operation

*2
Using a touch-tone phone, you can call your
phone number from outside and access the
unit to listen to messages or change
answering system settings. The unit's voice
guidance prompts you to press certain dial
keys to perform different operations.
Remote access code
A 3-digit remote access code must be entered
when operating the answering system
remotely. This code prevents unauthorized
parties from listening to your messages
remotely. The default setting is "111".
53
N
continue from step 2, "Making cellular
calls", page 22.
2011/12/07 19:54:00
53