Storing Your Grass Trimmer; Maintenance; To Replace Cut Line; Assembly Of The Wall Mount Brackets - Worx WG165 Instructions Manual

2-in-1 cordless li-ion grass trimmer/edger
Table of Contents

Advertisement

Available languages

Available languages

To REPLaCE CuT LiNE.

For your convenience it is recommended you
buy spool and line assembly.
To fit spool and line assembly:
Remove old spool.
Place new spool into cap with cut out areas
of the spool in line with eyelet.
Release line from cleat and feed line through
eyelet.
Refit the cap.
To fit nylon line only:
waRNiNG! Take approximately 10ft
(3 m) of line. Insert 5/8" (15 mm ) of
line into the spool holes and wind line in the
direction of the arrows on the top of the spool.
Your Trimmer is designed to use only line
with a maximum diameter of 0.065" /
1.65mm.
imPoRTaNT: Leave approximately 4"
(100mm) of line unwound and place into cleat.
Care should be taken to ensure that the line is
neatly coiled on the spool. Failure to do so will
impair the efficiency of the automatic line feed.
Then fit spool as described in "To fit spool
and line complete".
sTorING YoUr GrAss
TrIMMEr
a) aSSEmBLy oF THE waLL mouNT
BRaCkETS (See Fig L)
Tighten all the screws securely. Carefully check
the bracket after mounting to make sure that
no movement can occur during use.
waRNiNG: Always make sure your
wall-mount bracket is securely mounted
to the wall. Failure to do so could result in an
accident, resulting in possible serious personal
injury.
B) SToRiNG youR GRaSS TRimmER
(See Fig m)
Adjust the auxiliary handle position close to
the main handle and lower it into the bracket,
now the grass trimmer can be stored into the
wall mount bracket as illustrated.
2-in-1 Cordless Li-ion Grass Trimmer/Edger

MAINTENANCE

After use, disconnect the battery from the
mains and check for damage.
Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never
use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep all
working controls free of dust.
13
13
EN

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents