Storing Your Grass Trimmer; Maintenance - Worx WG157E Safety And Operating Manual

WORKING HINTS
1. AUTOMATIC LINE FEED SYSTEM
When initially switching on the trimmer, a small
length of line is fed out. A 'clattering' noise will be
heard when the lines hit the Line Cutter. DO NOT
BE ALARMED. This is quite normal. After about 5
seconds the line will be cut to the correct length and
the noise will reduce as the motor gains full speed.
If the noise of the line being cut can't be heard,
more line will need to be fed out. To feed more line,
it is first necessary to allow the trimmer to stop
completely; it must come to a complete rest, then
restart, allowing the motor to reach full speed.
Repeat above until you hear the line hitting against
the Line Cutter.
2. MANUALLY FEEDING THE LINE (SEE FIG. H)
Press and release manual line feed button (13), whilst
gently pull out the lines until the lines reaches the
line cutter.
If the line extends past the line cutter, too much line
has been fed out.
If too much line is fed out, remove the cutting head
cover and rotate the spool anti-clockwise until the
line is at the desired length.
STORING YOUR GRASS
TRIMMER
12
Always remove the battery pack from
your trimmer after use.
Store in a dry place where the trimmer and battery
can be protected from damage.

MAINTENANCE

Always remove the battery pack from
your trimmer after use.
Always check the product prior to being used for any
damage.
Never operate your product if it is damaged.
Your power tool requires no additional lubrication
or maintenance. There are no user serviceable parts
in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry
place. Keep the motor ventilation slots clean. Keep all
working controls free of dust.
2-in-1
Grass Trimmer/Edger
WG157E
WG157E.X