Environmental Protection; Storing Your Grass Trimmer; Maintenance - Worx WG183E Manual

2 . MANUALLY FEEDING THE LINE (See Fig. H)
Press and release manual line feed button, whilst gently
pull out the lines until the lines reaches the line cutter.
When the required amount of line is fed out, gently pull
on the second line (there is no need to press the manual
line feed button again). If the line extends past the line
cutter, too much line has been fed out. If too much line is
fed out, remove the spool cap and rotate the spool anti-
clockwise until the line is at the desired length.
Removing the Cap (See Fig. I)
Press and hold in the two latches. Pull the spool cap
away from the Cutting Head. Keep the cap and spool
holder clean from debris. To replace the cap, press it
firmly towards the spool holder. Ensure that it is correctly
connected by trying to remove it without depressing the
two latches.
Changing the Line Spool (See Fig. K, L)
First take off the cap and remove the old spool. Place
new spool into cutting head. Feed one line through the
eyelet, then repeat for second line (See Fig. L).
Release line from cleat on the Spool. Reattach the cap.
WARNING! Your Trimmer is designed to only use line
with a maximum diameter of 0.065"(1.65mm). Only
use nylon line.
IMPORTANT - Always wind the line onto the upper
section of the spool first.
3. Manually winding the line (See Fig. M, N, O, P)
Take approximately 5 m line and insert 15 mm of line into
one of the holes in the upper section of the spool. Wind
the line in the direction of the arrows on the top of the
spool.
Leave approximately 100mm of line unwound and place
it into the cleat. Repeat on the lower section of spool.
Care should be taken to ensure that the line is neatly
coiled on the spool. Failure to do so will impair the
efficiency of the automatic line feed. Then fit the spool
as described above in "Changing the Line Spool".
STORING YOUR GRASS
TRIMMER
Always remove the battery pack from your
trimmer after use.
To store your GRASS trimmer
The trimmer is provided with a hanging slot for storing
the trimmer on the wall. (See Fig. Q)
Store in a dry place where the trimmer and battery can
be protected from damage.

MAINTENANCE

Always remove the battery pack from your
trimmer after use.
Always check the product prior to being used for
any damage.
After use, disconnect the battery from the tool and check
for damage.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Cordless Grass Trimmer
Always store your power tool in a dry room temperature
location. Keep the motor ventilation slots clean. Keep all
working controls free of dust.
ENVIRONMENTAL
PROTECTION
Disposal
The machine, its accessories and packaging
materials should be sorted for environmentally
friendly recycling. The plastic components are
labeled for categorized recycling.
11
EN