Assembly; Operation Instructions; Assembly Of The Safety Guard; Assemble Of The Edger Wheel - Worx WG165 Instructions Manual

AssEMBLY

1. aSSEmBLy oF THE SaFETy GuaRd

(See Fig a)
Fix the safety guard to the trimmer head
making sure the sides are located into the
grooves on the trimmer head.
Secure the safety guard onto the trimmer
head with the screw (a) provided.

2. aSSEmBLE oF THE EdGER wHEEL

(See Fig B)
Insert the edger wheel assembly onto grooves
of cutting head. Make sure the groove of the
wheel is locked in the metal plate.
Press the release button (b) on the wheel and
pull out to take off the wheel.

oPErATIoN INsTrUCTIoNs

waRNiNG! The charger and battery
pack are specially designed to work
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections
because of an electrical failure and hazard will
occur.
1. BEFoRE uSiNG youR CoRdLESS
GRaSS TRimmER
Your battery pack is UNCHARGED and you must
charge once before use.
The battery charger supplied is matched to the
Li-ion battery installed in the machine. Do not
use another battery charger.
2. CHaRGiNG youR BaTTERy PaCk
The Li-ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit: The trimmer head no longer rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery to cool
down before recharging.
3. To REmovE oR iNSTaLL BaTTERy
PaCk (See Fig C)
Depress the battery release button to
2-in-1 Cordless Li-ion Grass Trimmer/Edger
release battery pack from your trimmer.
After recharging, insert the battery pack into
trimmer's battery port. A simple push and
slight pressure will be sufficient.
4. SaFETy oN/oFF SwiTCH (See Fig d)
Your switch is locked off to prevent accidental
starting. Depress lock off button (c) then on/off
switch (d) and release lock off button (c). Your
switch is now on. To switch off, just release the
on/off switch.
waRNiNG! The cutting head
continues to rotate after the
trimmer has been switched off; wait until
it has completely stopped then lay down
the tool.
5. adJuSTmENT oF THE TELESCoPiC
SHaFT (See Fig E)
Unscrew the locking collar (4) in the direction
indicated to unlock.
Adjust the length of the telescopic shaft to the
most comfortable length.
Tighten the lower locking collar.
6. maiN HaNdLE RoTaTioN (See Fig
F1&F2)
Holding the lower housing then pull upward
the shaft, then rotate 90 degree clockwise,
then release, the shaft will be locked in
position automatically.
7. adJuSTmENT oF auxiLiaRy HaNdLE
(See Fig G)
Pull up the auxiliary handle locking lever (5).
Hold the lever and rotate the auxiliary handle
to the most comfortable and balanced
position.
Release the lever, your auxiliary handle has
been locked.
8. adJuSTmENT oF THE TRimmER
HEad aNGLE To THE SHaFT (See Fig
H1&H2)
Adjust the trimmer head angle downwards,
Put your one foot on the motor house, then
grip the main handle, apply adequate force to
adjust, as shown in Fig H1.
Adjust the trimmer head angle upwards, Put
your one foot on the safety guard, then grip
11 11
EN