Assembly And Operation - Worx WG184E Original Instructions Manual

And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING! To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
ASSEMBLY & OPERATION
Action
Assembly
Assembling the Main Handle
Assembling the Safety Guard
Installing and Removing the Battery
12
Pack
NOTE:
• This machine will only run when
2 batteries are installed. It is
recommended to use the same two
batteries and charge the two batteries
at the same time.
• Using two different sized batteries
or if one battery isn't fully charged
then the machine will only run to the
lowest common denominator.
Checking the battery charge
condition
NOTE: Fig. C3 only applies for the
battery pack with battery indicator
light.
Charging the battery pack
NOTE:
• The batteries are shipped
uncharged. Each battery must be
fully charged before the first use.
• Always fully charge the two
batteries at same time. More details
can be found in charger's manual.
Battery power indicator on the
machine
See details in BATTERY STATUS
section
Operation
2*20V/33cm Li Grass Trimmer/Edger
On/Off Switch
Warning! The cutting head
continues to rotate after the
trimmer has been switched off; wait
until it has completely stopped then
lay down the tool.
Trimming
-Adjusting the Trimmer Head
-Adjusting the Auxiliary handle
Edging
-Edger wheel storage
Command feeding the line
Manually feeding the line
Replacing the trimmer line and spool
Manually winding the line
Figure
BATTERY STATUS (See Fig. C5)
See Fig. A
Before starting or after use, press the button beside the power
indicator light on the machine to check the battery capacity.
See Fig. B
The indicator lights displays the battery condition as follows:
Battery power
indicator status
Five green lights
(
See Fig. C1,
illuminated.
C2
Two, three or four
green lights are
illuminated.
Only one green light
(
illuminated.
See Fig. C3
No light is
illuminated.
Only one light is
flashing twice per
cycle.
See Fig. C4
Only one light is
flashing three times
per cycle.
See Fig. C5
Only one light is
flashing four times
per cycle.
Battery condition
The two batteries are in a
) are highly charged condition.
The two batteries have a
remaining charge. The more
lights are illuminated, the
more battery capacity.
At least one battery is
) is depleted and needs to be
charged.
At least one battery is not
fully installed or battery may
be defective.
At least one battery is
over discharged (please
refer to the battery charge
condition), please recharge
the two batteries at once
before use again or storage.
At least one battery is hot,
wait for them cool down
before start again.
The machine is over load.
Raise the cutting height or
push slowly.
See Fig. D
See Fig. E
See Fig.
F1, F2
See Fig. G
See Fig.
H1-H4
See Fig. I
See Fig. J
See Fig. K
See Fig. L,
M, N
See Fig. O,
P , Q, R
EN