Assembly And Operation - Worx WG284E Manual

Charger rating
Charging time
(approx.)
Battery pack:
2.0 Ah (1pc)
2.0 Ah (2pcs)
Machine Weight
*Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
** Charger output 1 and output 2 mean two ports
with the same output voltage and current.
ACCESSORIES
Battery pack (WA3551)
Charger (WA3883)
Blade sheath
10
Safety guard
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended use
The machine is intended for cutting and trimming
hedges and bushes in domestic use.
Warning: Do not use the product without
attaching the guard and front handle.
ASSEMBLY & OPERATION
ACTION
BEFORE USING YOUR CORDLESS
HEDGETRIMMER
Assembling the safety guard
Cordless Hedge Trimmer
Input: AC 100-
240V ~ 50-60Hz,
Output 1: 20V
, 2.0A **
Output 2: 20V
, 2.0A **
0.5 hr
1 hr
4.3 kg 3.5 kg
WG284E WG284E.9
2
1
1
1
FIGURE
See Fig. A
Assembling the front handle
NOTE : The handle is designed to
prevent being assembled in wrong
/
direction . If you find it cannot be
installed, please turn it around.
Checking the battery charge condition
NOTE : Fig. C only applies for the
battery pack with battery indicator light.
Charging the battery pack
/
NOTE :
/
• The batteries are shipped
uncharged. Each battery must be
fully charged before the first use.
• Always fully charge the two
batteries at same time. More details
can be found in charger's manual.
Installing and Removing the battery
pack
NOTE :
• This machine will only run
when 2 batteries are installed.
It is recommended to use the
same two batteries and charge
the two batteries at the same
time.
/
• When you use two batteries
/ with different power, the
machine will only run to the
lower common denominator.
OPERATION
Power indicator light
See details in BATTERY STATUS part
IMPORTANT:
When only one light is illuminated,
your battery is overly discharged,
even though the trimmer may still
be capable of hedge trimming.
Continuing to operate your
trimmer with the battery in this
discharged condition may reduce
the life and performance of your
battery.
When no light is illuminated,
at least one battery is not fully
installed or battery may be
defective, please double check
the batteries are fully seated into
position.
Remove the blade sheath
Starting and stopping
See Fig.
B1, B2
See Fig. C
See Fig. D
See Fig. E
See Fig. F
See Fig. G
See Fig.
H1, H2
EN