Brother MFC-7840W Quick Setup Manual page 24

STEP 2
Installing the Driver & Software
Using the Setup Wizard from the control panel LAN menu for wireless
network configuration (Infrastructure Mode)
Important
Make sure that you have finished the
instructions from step 1 Setting Up the
Machine on pages 4 through 10.
These instructions will install your Brother machine in
a typical small office or home wireless network
environment in infrastructure mode, using a wireless
router or access point that uses DHCP to assign IP
addresses.
Before you begin you must know your wireless
network settings.
1
Write down the wireless network settings of
your access point or wireless router.
SSID (Service Set ID or Network name)
_________________________
WEP Key (if needed)
_________________________
WPA-PSK Password (if needed)
_________________________
Encryption (TKIP or AES)
_________________________
LEAP user name (if needed)
_________________________
LEAP password
_________________________
See Chapter 3 of the Network User's Guide for
more details.
2
Plug the AC power cord into an AC outlet. Turn
the power switch on.
Improper Setup
If you have previously configured the wireless
settings of the machine you must reset the
network (LAN) settings before you can
configure the wireless settings again.
Press Menu, 5, 2, 6 (or Menu, 5, 0, 1) and then
press 1 to accept the change.
3
On your machine, press Menu, 5, 2, 2.
WLAN Enable ?
1.On 2.Off
Press 1 to choose On. The wired network
interface will become inactive with this setting.
22
4
The machine will search for your network and
display a list of available SSIDs. You should
see the SSID you wrote down earlier. If the
machine finds more than one network use the
or to choose your network, then
press OK. Go to step 8.
Select ab or OK
salesgroup
Note
It will take several seconds to display a list of
available SSIDs.
If your access point is set to not broadcast the
SSID you will have to manually add the SSID
name. Go to step 5.
5
Select <New SSID> using
OK. Go to step 6.
Select SSID&Set
<New SSID>
6
Enter a new SSID and press OK.
SSID:
7
Press or to choose Infrastructure,
then press OK.
Mode Select
Infrastructure
®
Macintosh
or and press