Centering The Cd Drive Mechanism - Bang & Olufsen BeoSound 9000 Reference Book

Centering the CD drive mechanism

The CD mechanism is spring suspended in order
to make the BeoSound 9000 'party-safe'. By
centering the CD mechanism, you adjust the
tension of the spring suspension to allow for
different placements.
It is very important for the functioning of the CD
player that you adjust the spring suspension
correctly!
The spring suspension in the two adjustment
holes can be set to four different positions:
a) Use this setting when BeoSound 9000 is placed
in the Bracket as in fi gs 6 and 7.
b) Use this setting when BeoSound 9000 is placed
either on its Stand, or hung vertically on the wall
as in fi gs 1 and 3.
c) Use this setting when BeoSound 9000 is hung
horizontally on the wall as in fi g 2.
d) Use this setting when BeoSound 9000 is placed
either fl at on a table, or in the Bracket as in fi gs 4
and 5. This is the factory setting.
How to center the spring suspension
Enclosed with the Stand and the Brackets, you
will fi nd a small plastic tool, which you must
use for this purpose:
> Locate the two adjustment holes in the bottom
plate of BeoSound 9000.
> Pry off the two small plastic plugs (using the
chisel-shaped end of the tool).
> Insert the other end of the tool (the arrow-
shaped end) and turn the tool so that the arrow
in each hole points into the correct direction.
> When fi nished put back the two plastic plugs
again.
In all but the fl at and the near fl at positions, both
arrows in the holes must point upwards when
fi nished. In the fl at position (factory setting) they
must point towards the centre of BeoSound 9000.
9
a
b
d c