Service Messages - QMS Magicolor 6100 Operation Manual

 "

&

. 
&
. 
This service message...
CALL FOR SERVICE C3 NVRAM ERROR
CALL FOR SERVICE C4 ENG CTRLR HW
CALL FOR SERVICE C7 TIMING CLOCK
CALL FOR SERVICE D1 Y CLUTCH
CALL FOR SERVICE D2 M CLUTCH
CALL FOR SERVICE D3 C CLUTCH
CALL FOR SERVICE D4 K CLUTCH
CALL FOR SERVICE D5 YK SOLND
CALL FOR SERVICE D6 MC SOLND
CALL FOR SERVICE E1 DEVLPR MOTOR
CALL FOR SERVICE E2 MAIN MOTOR
CALL FOR SERVICE E3 DRUM ERROR
CALL FOR SERVICE E4 TONER SENSOR
CALL FOR SERVICE E5 ROLLER SOLND
CALL FOR SERVICE E6 CLEAN SOLND
CALL FOR SERVICE E7 CLEAN CLUTCH
CALL FOR SERVICE E8 FUSER CLUTCH
CALL FOR SERVICE E9 BELT MARKER
CALL FOR SERVICE EL ERASE LED
CALL FOR SERVICE F0 COOLING FAN
CALL FOR SERVICE F2 OZONE FAN
$
Means...
An error has been detected with
the item indicated in the service
message. Correction of these
errors is performed by QMS-
qualified service personnel only.
Contact your local vendor.
» Note: A service message
sometimes occurs as a result of
an unusual combination of
events, not because of an actual
problem. When the printer stops
and a service message displays
in the message window, turn the
printer off and then back on. This
often clears the service message
indicator, and printer operation
resumes. Always try this before
making a service call.
Service calls should be placed to
the vendor from whom you
purchased the printer. If you
cannot get service from your
vendor, see appendix A, "QMS
Customer Support," for more
information.