Power Board; Removing The Power Board - Toshiba NB200 Maintenance Manual

4 Replacement Procedures
4.7

Power Board

Removing the Power Board

Remove the power board according to the following procedures and Figure 4.12.
1. Carefully remove any adhesive tape covering the power board cable.
2. Use tweezers to release the latches on the left and right sides of the connector by pushing
in the direction of the arrows in Figure 4.12.
3. Remove the power board cable from the motherboard.
4. Press down the latch that protrudes to the power board on its right side. Push the power
board in the direction indicated in figure 4.12 and slide the power board out.
5. Remove the power board from the logic upper assembly.
Note: Be careful not to damage the Power Board when connecting it with the cable. Make
sure the card is seated in the correct position.
NB200 Maintenance Manual
Error! Style not defined. Error! Style not defined.
Figure 4.12 Removing the Power Board
4-20