Toshiba NB200 Maintenance Manual page 60

Hide thumbs Also See for NB200:
Table of Contents

Advertisement

2 Troubleshooting Procedures
41
Procedure 2: Connector and replacement check
Procedure 1
Diagnostic test
Run the functioning Program on Windows model, which will display the MIC test result.
If tests and diagnostics result abnormal go to Procedure 2. If an error is not located, the MIC
module functioning is properly.
Procedure 2
Connector and replacement check
The MIC line or system board may be disconnected or damaged. Disassemble the computer
following the steps described in Chapter 4, Replacement Procedures, and perform the
following checks.
Check 1
Make sure that the MIC line is securely slotted into the system board. If the
problem remains, go to Check 2.
Check 2
The MIC line may be damaged. Replace it with a new one following the
instructions in Chapter 4. If the problem still exists, perform Check 3.
Check 3
The system board may be damaged. Replace it with a new one following the
instructions in Chapter 4.
2.16
3D Sensor Troubleshooting
NB200 Series Maintenance Manual
41

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents