Toshiba NB200 Maintenance Manual page 61

2 Troubleshooting Procedures
42
The operation or system board may be the reason of 3D sensor fault. Either of these two may
be damaged. To determine if the computer's 3D is functioning properly, perform the
following procedures. Figure 2-16 outlines the process. Start with Procedure 1 and continue
with the other procedures as instructed.
Procedure 1: Diagnostic test
Procedure 2: Replacement check
Procedure 1 Diagnostic test
Run the functioning Program on Windows model, which will display the 3D test result.
If tests and diagnostics result abnormal go to Procedure 2. If an error is not located, the 3D
functioning is properly.
NB200 Series Maintenance Manual
Figure 2.16. 3D sensor troubleshooting process
42