Toshiba NB200 Maintenance Manual page 35

Hide thumbs Also See for NB200:
Table of Contents

Advertisement

2 Troubleshooting Procedures
Procedure 3
Connector and replacement check
The LCD module and system board are connected to the display circuits. Any of these
components may be damaged. Refer to Chapter 4, Replacement Procedures, for instructions
on how to disassemble the computer and then perform the following checks:
Check 1
Make sure the DDR module is seated properly. Test display again. If the problem
still exits, replace the DDR RAM module. If the problem still exists, perform
Check 2.
Check 2
Replace the LCD module with a new one and test display again. If the problem
still exists, perform Check 4.
Check 3
Replace the LCD cable with a new one and test display again. If the problem still
exists, perform Check 5.
Check 4
The system board may be damaged. Replace it with a new one.
NB200 Series Maintenance Manual
16

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents