Installing The Hinge Cover And Keyboard - Toshiba NB200 Maintenance Manual

Error! Style not defined. Error! Style not defined.

Installing the Hinge Cover and Keyboard

Install the hinge cover and keyboard according to the following procedures.
1. Attach the cable from the underside of the keyboard to the connector on the logic upper
assembly.
2. Seat the keyboard in its correct position making sure the four hooks on either side are
fastened.
3. Close the laptop.
4. Seat the hinge cover in the correct position and firmly click into place.
5. Turn the laptop upside down. Make sure all three hinge cap hooks are firmly in place.
6. Secure the laptop with twelve screws as indicated in Figure 4.8:
 seven M2.5x6 screws
 five M2.5x4 screws
7. Fasten any WLAN or modem antennas to their respective connectors.
NB200 Maintenance Manual
4 Replacement Procedures
4-19