Installing The Cabinet; Cabinet Installation Precautions - D-Link DGS-6600 Series Hardware Installation Manual

DGS-6600 Layer 3 Chassis Ethernet Managed Switch Hardware Installation Guide
• Does the intended installation location have a power supply that meets the Switch requirements and
does the intended location have the appropriate rated AC requirements.
• The intended installation location has the required network cabling installed.

Installing the Cabinet

Cabinet Installation Precautions

Please follow the recommendations below when installing the cabinet:
• Ensure that all the expansion bolts for fastening the cabinet base to the ground are installed from the
bottom up and tightened in the correct sequence (large plain washer, spring washer, and nut), and
ensure that all the expansion bolts are aligned with the installation holes on the base of the cabinet.
• Ensure that the cabinet is stable and sturdy after installation has been completed.
• Ensure that the cabinet is installed on the ground vertically.
• Ensure that the front/back doors of the cabinet can open and close properly when installation is com-
plete. Also verify that the cabinet locks are functioning and that there are a complete set of keys.
• Ensure that any labeling on equipment is accurate.
• Ensure that all the back panels of the cabinet are installed.
• Ensure that all the screws and bolts that will be used to install rack equipment are of the same type.
• Ensure that all the boards installed in the equipment are secure and that all fastening screws are prop-
erly tightened.
• In order to prevent rodents and other small animals from entering the cabinet, the cabling inlets at the
top and bottom of the cabinet should be fitted with rodent-resistant nets with seams that are no greater
than 1.5cm in diameter.
• The cabinet should always have a set of antistatic wrist bands available.
39