Dgs-6600-Cm-Ii Management Module - D-Link DGS-6600 Series Hardware Installation Manual

DGS-6600 Layer 3 Chassis Ethernet Managed Switch Hardware Installation Guide

DGS-6600-CM-II management module:

The basic appearance of the DGS-6600-CM-II management module is shown in Figure 1-6. The DGS-6600-CM-
II management module is designed to manage all features of the DGS-6608 Switch including: system switching,
controlling user access, managing user access, controlling the system status, managing routing, controlling
maintenance on the network and controlling network operations. The DGS-6600-CM-II management module
needs to be inserted in slot 1 in DGS-6604 and slot 4 and 5 in the DGS-6608
NOTE: The DGS-6608 needs at least one DGS-6600-CM-II management modules to oper-
ate.
Interface
UART Console Interface
The DGS-6600-CM-II front panel provides two types of UART Console Interface. The first console interface is an
RS-232 connector and the second console interface is a USB connector. These two interfaces are mutually
exclusive; the USB interface has a higher priority. If the Switch is being managed via the RS-232 console
connection and a USB connection is established, the CLI engine will use the USB connection and automatically
disconnect the user that is connected to the Switch via the RS-232 console connection.
Out-of-Band Management Port
The DGS-6600-CM-II module features an out-of-band Management port. The management port uses an RJ-45
connected so it can be easily connected to a notebook computer using a standard Ethernet cable. Connect to the
port for out-of-band management using a web browser or Telnet command prompt interface. The Management
port is enabled by default, so it can be used for the first time that you connect to the Switch.
To use the management port, use an Ethernet cable to connect the port to the Ethernet interface of a computer
used for Switch management. The default IP address of the management port is 10.90.90.90 with a subnet mask
of 255.0.0.0, make sure the computer used for Switch management has a non-conflicting IP address in the
10.0.0.0/8 subnet.
Figure 1-6 Basic Appearance of DGS-6600-CM-II
14