Enabling And Configuring The Web User Interface - D-Link DGS-6600 Series Hardware Installation Manual

DGS-6600 Layer 3 Chassis Ethernet Managed Switch Hardware Installation Guide

Enabling and Configuring the Web User Interface

To re-enable the Web interface after it has been disabled by the user, enter the following CLI commands in
privileged EXEC mode:
DGS-6600:2>enable
DGS-6600:15#configure terminal
DGS-6600:15(config)#ip http server
DGS-6600:15(config)#end
DGS-6600:15#
The following example shows how to configure the TCP port number for the WEB UI to be 8000:
DGS-6600:2>enable
DGS-6600:15#configure terminal
DGS-6600:15(config)#ip http service-port 8000
DGS-6600:15(config)#end
DGS-6600:15#
Display the Web UI settings as per the example below (blue text):
DGS-6600:15(config)#show system protocol-state
Password Encryption
SNMP Server
Sys Logging
TELNETv4
TELNETv6
WEB
SSH
IP Domain Lookup
RMON
Spanning Tree Version
LACP
802.1x
GVRP
RIP
OSPF
BGP
Multicast Routing
DVMRP
PIM-DM
PIM-SM
IGMP Snooping
IGMP
DHCPv4 Relay
DHCPv4 Client
DHCPv4 Server
AAA Authorization
Vlan Tunnel
RIPng
OSPFv3
IPv6 DHCP Relay
IPv6 DHCP Client
VRRP
DGS-6600:15(config)#
:Disabled
:Disabled
:Enabled
:Enabled(TCP:23)
:Enabled(TCP:23)
:Enabled(TCP:8000)
:Disabled(TCP:22)
:N.A
:Disabled
:Enabled(MSTP)
:Enabled
:Disabled
:Disabled
:Enabled
:Enabled
:Disabled
:Disabled
:Enabled
:Enabled
:Enabled
:Enabled
:Enabled
:Disabled
:Enabled
:Disabled
:Disabled
:Disabled
:Disabled
:Disabled
:Disabled
:Disabled
:Enabled
66