Installing The Control Unit - Honda 08E91-E54-100 Installation Insructions

Installing the Control Unit

70. Using isopropyl alcohol on a shop towel, clean the
area where the urethane tape will attach.
VEHICLE UNIT
(Clean with
isopropyl alcohol.)
71. Attach a piece of urethane tape to the vehicle unit as
shown.
72. Plug the antenna cable connector and the engine
starter connector into the control unit.
CONTROL
UNIT
ENGINE STARTER
HARNESS 28-PIN
CONNECTOR
© 2013 American Honda Motor Co., Inc. – All Rights Reserved.
URETHANE
TAPE
Q0N2305AG
ANTENNA
CABLE
CONNECTOR
QC50917AB
AII 50024-50373 (1308)
73. Attach the control unit bracket to the control unit.
CONTROL
UNIT
74. Secure the clip from the engine starter harness fuse
block, and the clip from the engine starter harness
into the control unit bracket.
CONTROL UNIT
BRACKET HOLE
HOLE
CONTROL UNIT
BRACKET
QC50918AB
CLIP
FUSE
BLOCK
ENGINE
STARTER
HARNESS
CLIP
Q0N2308BG
19 of 25