Bios Security Features - J&W G31 + ICH7 Chipset User Manual

G31 Series
► APM Configuration
This item allows you to set Power Management/APM between Enable or disable, Power
down video in suspend or standy Mode, Power down hard disk in suspend or standby
mode, Go into suspend in the specified time, Select the Duty Cycle in Throttle mode,
Monitor KBC ports 60/6 and go into On/Off, or suspend when power button is pressed.
► ACPI Configuration
This item allows you to select ACPI Suspend Type (S3 mode is optional ) and allows
you to set or Enabled / Disabled the Advanced configuration.
4.5.9 BIOS Secturity Features
CMOS Setup Utility - Copyright (C) 1985-2004,American Megatrends, Inc.
Security Settings
Supervisor Password : Not
User Password
Change Supervisor Password
Change User Password
→←
:Move Enter:Select
↑ ↓
F7: Previous Values
When Chage Supervisor/User Password function is selected, the following message
appears at the center of the screen to assist you in creating a password.
Type the password, up to eight characters, and press <Enter>. The password typed now
will clear any previously entered password from CMOS memory. You will be asked to
confirm the password. Type the password again and press <Enter>.
Note:
Don't forget your password. If you forget the password, you will have to
open the computer case and clear all information in the CMOS before you can start
up the system. But by doing this, you will have to reset all previously set options.
You may also press <Esc> to abort the selection.
BIOS Secturity Features
Installed
: Not Installed
[Press Enter
Press Enter
[Press Enter ]
+/-/:Value
F8: Fail-Safe Defaults
Enter New Password:
Enter New Password:
- 2 -
Install or Change the
password.
]
F10:Save ESC:Exit
F9: Optimized Defaults
User's Manual
Item Help
F1:General Help