Gtpp Group Configuration Verification - Cisco ASR 5000 Series Administration Manual

GGSN Service Configuration Procedures
In case no GTPP group is configured in this context, system creates a default GTPP group named "default" and
all the CGF servers and their parameters configured in this context are applicable to this "default" GTPP group.
Command for CGF
may interfere with ggsn-service configured with the same ip address. Multiple interfaces can be configured
within a single context if needed.
For more information on GTPP dictionary encoding in addition to referring Command Line Interface Reference,
refer AAA Interface Administration and Reference.
For better performance, it is recommended to configure maximum number of CDRs as 255 with
command.
Operator can select transport layer protocol as TCP or UDP for Ga interface with
command.
Multiple GTPP server can be configured using multiple instances of this command subject to following limits:

GTPP Group Configuration Verification

Step 1
Verify that your CGFs were configured properly by entering the following command in Exec Mode:
This command produces an output similar to that displayed below:
Step 2
Verify configuration for errors by entering the following command in Exec Mode:
OL-22944-02
Total 4 GTPP server in one GTPP group
Total 32 GTPP server in one context
Total 9 GTPP groups (1 default and 8 user defined GTPP groups) can be configured in one context.
Number of CGFs in 1 GTPP group is limited to 4 and a total of 32 CGF servers across all GTPP
groups in one context are configurable.
is optional and configuring gtpp charging-agent on port 3386
Cisco ASR 5000 Series Gateway GPRS Support Node Administration Guide ▄
GTPP Accounting Support Configuration ▀