Ip Interface And Udp Port Binding For Pi Interface - Cisco ASR 5000 Series Administration Manual

GGSN Service Configuration Procedures
Notes:
<
configured within a destination context.
<

IP Interface and UDP Port Binding for Pi Interface

Use the following example to bind the FA service to an local IP interface and specify the maximum number of
subscribers that can access this service. Binding an interface to the FA service causes the interface to take on the
characteristics of a Pi interface.
Notes:
<
<
<
configured to any integer value from 0 to 500,000. The default is 500,000.
<
number is 434.
For more information on commands/keywords that configure additional parameters and options, refer FA Service
Configuration Mode Commands chapter of Command Line Interface Reference.
OL-22944-02
> is name of the context to use for FA service configuraiton. Generally FA should be
> is name of the FA service where other parameters have to configure for FA functionality.
> is name of the FA service which is created to configure FA functionality.
> is the local IP address in IPv4/IPv6 notation for providing Pi interfae characteristics.
> is the maximum number of subscribers that can access this service on this interface. This can be
Important:
The maximum number of subscribers supported is dependant on the session
capacity license installed and the number of active PACs/PSCs installed in the system. For more
information on session capacity license, refer to the Software Management Operations chapter of the
System Administration Guide.
> is the UDP port number from 1 through 65535 to be used for Pi interface. Default port
Cisco ASR 5000 Series Gateway GPRS Support Node Administration Guide ▄
FA Services Configuration ▀