Revocation Message Configuration; Fa Service Configuration Verification - Cisco ASR 5000 Series Administration Manual

▀ FA Services Configuration
<
from the HA. It is measured in seconds and can be configured to any integer value from 1 to 65535. The
default value is 45.
For more information on authentication mn-aaa commands/keywords that configure additional parameters and
options, refer FA Service Configuration Mode Commands chapter of Command Line Interface Reference.

Revocation Message Configuration

Use the following example to configure the FA service for controlling the negotiation and sending of the I-bit in
revocation messages:
Notes:
By default the system will not send the I-bit in the revocation message.

FA Service Configuration Verification

Step 1 Verify that your FA service is configured properly by entering the following command in Exec Mode:
The output from this command should look similar to the sample shown below. In this example an FA service
named fa1 was configured in the isp1 context.
▄ Cisco ASR 5000 Series Gateway GPRS Support Node Administration Guide
Important:
In addition, because only a single Mobile IP or proxy-Mobile IP session is
supported for IP PDP contexts, this parameter must remain at its default configuration.
> is the maximum amount of time that the FA service waits for a Registration Rely message
GGSN Service Configuration Procedures
OL-22944-02