Installation Of Unit Dial And Cover Top - Epson PhotoPC 850Z Service Manual

EPSON PhotoPC 850Z

4.3.12 Installation of Unit Dial and Cover Top

1. Install the Holder Battery (see 4.3.9 "Installation of Holder Battery").
2. Install the SY1 Board (see 4.3.11 "Installation of SY1 Board").
3. Set the Cover Top on the Holder Monitor using a hook on the Cover Top,
and secure the Cover Top with one screw (1.7x4.0) (2).
(Tightening torque: 1.0 ~ 1.4kgf-cm)
4. Fix the Earth on the Unit Dial with one screw (1.7x4.0) (4).
(Tightening torque: 1.0 ~ 1.4kgf-cm)
5. Fix the Unit Dial with 2 screws (1.7x4.0) (5).
(Tightening torque: 1.0 ~ 1.4kgf-cm)
Disassembly and Assembly
Note:
Match the protrusion on
the Unit Dial with the
groove on the Cover Top.
Earth
Note:
Keep the
glossy
side up.
HOLDER BRKT GRIP
Figure 4-22. Installation of Unit Dial and Cover Top
Assembly Procedure
Revision A
Note:
Insert the rib on the Unit
Dial into the groove on
the Cover Top.
Hook
FPC of SY1 Board
Note:
Place this part under
the Holder Chassis B.
Note:
Place this part under
the Earth Terminal.
82