Installation Of Cabinet Back - Epson PhotoPC 850Z Service Manual

EPSON PhotoPC 850Z

4.3.14 Installation of Cabinet Back

1. Connect the harness of the ST1 Board to CN104 of the CA2 Board. Twist
the harness slightly and place it inside of the camera.
2. Affix the Pad (5) on the shield plate of the CA2 Board.
3. Install the Cabinet Back and fix it with 2 screws (1.7x5.0) (1).
(Tightening torque: 1.3 ~ 1.7kgf-cm)
4. Secure the Cabinet Back with one screw (1.7x3.5) (2).
(Tightening torque: 1.3 ~ 1.7kgf-cm)
5. Install the Cabinet Back and fix it with one screw (1.7x5.0) (3).
(Tightening torque: 1.3 ~ 1.7kgf-cm)
6. Install the Cabinet Back and fix it with one screw (1.7 x 3.0) (4).
(Tightening torque: 1.3 ~ 1.7kgf-cm)
Disassembly and Assembly
Harness of
SY1 Board
Figure 4-28. Installation of Cabinet Back
Assembly Procedure
Revision A
86