EPSON PhotoPC 850Z
4.3.7 Installation of Speaker
1. Install the SY2 Board (see 4.3.6 "Installation of Microphone and SY2
Board).
2. Attach the Spacer Speaker B (2) and the Speaker (3) to the Holder
Speaker (1).
3. Attach the Spacer Speaker F (4) to the Holder Speaker.
4. Fix the Speaker on the Holder Chassis with 2 screws (1.7x4.0) (5).
(Tightening torque: 1.0 ~ 1.4kgf-cm)
5. Connect the harness of the Speaker to CN181 of the CA2 Board, and
place the harness under the CA2 Board.
Disassembly and Assembly
CN181
Twist the
harness of the
Speaker and
place it under
the CA2 Board.
Assembly Procedure
Figure 4-17. Installation of Speaker
Revision A
To CN181
78