Propeller Diameter And Pitch, Influence On The Optimum Propeller Speed - Man B&W S80ME-C7 Project Manual

MAN B&W

Propeller diameter and pitch, influence on the optimum propeller speed

In general, the larger the propeller diameter D,
the lower is the optimum propeller speed and the
kW required for a certain design draught and ship
speed, see curve D in the figure below.
The maximum possible propeller diameter de-
pends on the given design draught of the ship,
and the clearance needed between the propeller
and the aft body hull and the keel.
The example shown in the figure is an 80,000 dwt
crude oil tanker with a design draught of 2.2 m
and a design speed of 4.5 knots.
When the optimum propeller diameter D is in-
creased from 6.6 m to 7.2. m, the power demand
is reduced from about 9,290 kW to 8,820 kW, and
the optimum propeller speed is reduced from 20
r/min to 00 r/min, corresponding to the constant
ship speed coefficient
∝ in section 2.02, page 2).
Fig. 2.02.01: Influence of diameter and pitch on propeller design
MAN B&W MC/MCC, ME-B, ME/MEC/MEGI engines
∝
= 0.28 (see definition of
Once an optimum propeller diameter of maximum
7.2 m has been chosen, the corresponding op-
timum pitch in this point is given for the design
speed of 4.5 knots, i.e. P/D = 0.70.
However, if the optimum propeller speed of 00
r/min does not suit the preferred / selected main
engine speed, a change of pitch away from opti-
mum will only cause a relatively small extra power
demand, keeping the same maximum propeller
diameter:
•
going from 00 to 0 r/min (P/D = 0.62) requires
8,900 kW i.e. an extra power demand of 80 kW.
•
going from 00 to 9 r/min (P/D = 0.8) requires
8,900 kW i.e. an extra power demand of 80 kW.
In both cases the extra power demand is only
of 0.9%, and the corresponding 'equal speed
curves' are
there is a certain interval of propeller speeds in
which the 'power penalty' is very limited.
MAN Diesel
∝ =+0. and ∝ =0., respectively, so
2.02
Page  of 2
178 47 032.0
198 38 782.5