Headset Instructions - Denwa Communications Mitel 8662 User Manual

Headset Instructions

When using a headset, press
If you have both a headset and a handset connected to your phone and you are using the
headset, you can quickly transfer audio to the handset by lifting the handset from the cradle.
Press
NOTES
To connect and activate the headset:
1. Insert the headset jack into the Headset port located on the back of the phone. See
2. Dial 317 to turn the headset on. HEADSET MODE ON appears.
To turn off Headset Mode and activate the handset and speakerphone:
Mitel ® 8662 IP Phone User Guide – Issue 15, February 2011
(Speaker) to connect to or disconnect from calls.
to transfer the call back to the headset before replacing the handset in the cradle.
The headset must be HAC.
If your headset has a power-saver mode, make sure the system administrator has
enabled the "Headset Connect Tone" feature. If this is not enabled, you may miss
the first few seconds of an incoming call.
"Phone Connectors" on page
Dial 317. HEADSET MODE OFF appears.
6.
Getting Started
Page 7