Smartreader Plus 10 Rtd Temperature Logger; Description; Setup - ACR Electronics SmartReader Plus Reference Manual

SmartReader Plus Data Loggers
65
1.13

SmartReader Plus 10 RTD Temperature Logger

The SmartReader Plus 10 is a temperature logger with four channels: an internal thermistor
channel and three external channels specifically designed for use with RTD (Resistance
Temperature Detector) temperature probes.
1.13.1

Description

Two, three, and four-wire RTDs may be used with the SmartReader Plus 10, however,
four-wire RTDs produce the highest accuracy. RTDs with a Temperature Coefficient
Resistance (TCR) of 0.00385 can be used with this data logger.
1.13.2

Setup

1. Connect the RTDs to the terminal strip. The connection varies depending on the type of
RTD used:
NOTE: For the best results, connect the jumper wire as closely as possible to
the probe.
2. Run TrendReader software.
3. In the setup window, assign equation numbers as follows:
For results in temperature:
Figure 10-1: SmartReader Plus 10
Copyright © 2010 ACR Systems Inc. All Rights Reserved.