Smartreader Plus Software Driver - ACR Electronics SmartReader Plus Reference Manual

1.2

SmartReader Plus Software Driver

TrendReader software uses a software driver to communicate with SmartReader Plus data
loggers. The software driver takes the form of two windows. The Status window, shown when
you contact the logger, is used to display the settings currently stored in the data logger. The
Setup window, shown when you select Edit Setup, is used to alter the current settings and
apply the changes to the data logger. The settings are divided into two main sections:
and Channels. Status contains information about sampling, memory and alarms. Each
channel of the logger contains information about the description, equation and Realtime value,
alarms, and calibration associated with the channel. You can control the level of detail that
you see for the settings by clicking on the "+" and "-" buttons at the left side to expand and
collapse the nodes.
When you want to clear the logger's memory and start a new logging session with new
parameters, select Edit Setup from TrendReader. In the Edit Logger Setup window, make
any necessary changes. To implement your changes, you can either click on Apply or OK.
OK will implement the changes and close the window whereas Apply will leave the window
Copyright © 2010 ACR Systems Inc. All Rights Reserved.
SmartReader Plus Data Logger
8
Status