Extron electronics DTP DVI 330 User Manual page 19

3. Locate, remove, and discard jumpers JMP2 and JMP3 from both units (see figure 13).
JMP2
JMP3
Transmitter
Figure 13. Jumper Locations
4.
Reinstall the covers on both units, securing in place with the screws removed in step 2.
5. Reinstall both units in their racks or other installation option (see
Transmitter and Receiver
6. If you are using STP cable, disconnect the cable shield from the connector at either
end of the cable.
7. Obtain a second 12V power supply, part number 70-775-01 (one supply is provided
with the transmitter and normally powers both units), and locally power both units (see
Power supply wiring
DTP DVI 330 Tx/Rx Transmitter and Receiver • Installation and Operation
Receiver
on page 11).
on page 8).
JMP2
JMP3
Mounting the
13