Installing The Belt Cover; Installing The Foot Switch - Brother KE-430B Instruction Manual

3. INSTALLATION

3-13.Installing the belt cover

e
r

3-14.Installing the foot switch

e
0070Q
1. Insert the connector of the foot switch e into the connector w of the control box q.
2. Install the foot switch e to the work table leg !2 with foot switch support plate A r, foot switch support
plate C t, the bolt y, spring washer u, flat washer i, bolt o, spring washer !0 and flat washer !1 as
shown in Figure A.
♦If foot switch support plate B !3 is used in a back-to-front position, it can be used as shown in Figure B.
1. Remove the screw !4 and rubber plug !5 .
* Note that the spring !6 will come out when the screw !4 is removed.
2. Turn foot switch support plate B !3 back to front, and then install it with the bolt !7 , spring washer !8 and
flat washer !9 as shown in Figure B.
NOTE:
If using the foot switch without installing it to the work table leg, move the foot switch at least 10 mm away from the
leg. If the foot switch is not fully in contact with the work table leg when the foot switch is used, for example, if it is
just hooked loosely onto the work table leg, it may cause the sewing machine to operate incorrectly.
If using the optional two-pedal foot switch, change the setting of DIP switch A on the oreration panel while referring
to "Setting the presser mode" on page 44.
16
w
q
[A]
q
w
[B]
KE-430B, 431B, 432B, 433B
1. Loosen the two screws w of the upper cover q.
2. Insert the belt cover e in the direction of the ar-
row, and then secure it with the two screws w and
the two screws r.
* It is not necessary to remove the belt cover e when
tilting back the machine head.
0069Q
r
u !1
y
i
!0
o
t !3
!2
!7
e
!4
!6
!5
!8 !9
0071Q
0072Q