Changing Special Functions Using The Memory Switches - Brother KE-430B Instruction Manual

13. CHANGING SPECIAL FUNCTIONS USING THE MEMORY SWITCHES

13. CHANGING SPECIAL FUNCTIONS USING THE MEMORY SWITCHES
The functions of the switches on the operation panel q can be changed to carry out special functions.
NOTE:
After changing the memory switch settings, press the power switch to turn the power off and then back on again.
The memory switches "00 - 2F" are set to OFF at the time of shipment.
1. Turn on the power switch.
2. While pressing the TEST switch w, press the BOB-
BIN. WIND switch e.
* "00 - -" will appear in the display window r.
3. Press the DISPLAY SET switches t to set the two
digits at the left of the display window r to the
corresponding number (00 to 4F) of the function
shown in the table below that you would like to
select.
4. When the BOBBIN. WIND switch e is pressed, the
two spaces at the right in the display window will
change from "- -" to "ON".
* If you press the RESET switch y at this time,
memory switches from 00 to 2F will all be set to
OFF ("--"), and memory switches from 30 to 4F
will be returned to their initial settings.
5. Press the TEST switch w.
* The display will return to normal.
Memory switches 00 - 0F
Switch
At the end of sewing, the feed plate will be returned to the sewing start point via
memo-00
mechanical home position.
Work clamp will move to the sewing start point, and then will be lifted.
memo-01 (The work clamp rises at the final stitch to enable the quick taking out of the
workpieces.)
Feed will move automatically to the next starting point at the same time as a user
memo-02 program is switched.
(Normally it moves to the starting point after sewing starts.)
When sewing using programs, the programs which have been set will be sewn in
memo-03
numerical order. (Cycle sewing mode is set.)
The sewing speed will be fixed at the minimum speed for the maximum pitch of the
memo-04 sewing data. (Set this to ON if you are concerned that vartations in pitch may cause
changes in the sewing speed.)
Increases the presser solenoid lifting force (Set to ON when using the optional
memo-05
spring for extra-heavy material)
memo-06 Enlargement and reduction ratio settings for X and Y become the same.
–
memo-07
memo-08 Test feeding is carried out stitch by stitch when the foot switch is depressed.
The sewing start point becomes the reference point for enlargements and
memo-09 reductions. (The reference point for enlargements and reductions is normally the
center of the sewing frame.)
* Work clamp does not close.
memo-0A
* Work clamp closes when it is lower.
memo-0b
Needle stops in up position during emergency stop.
memo-0c
(EMERGENCY STOP switch is available as an option.)
The bar tacking stitches (with a pitch of less than 1 mm) are also enlarged and
reduced. (Normally stitches with a pitch of less than 1 mm are not enlarged or
memo-0d
reduced.)
Test feeding will be performed at the same speed as that for actual sewing.
memo-0E
(This is used for checking feeding operation.)
After sewing is finished, the work clamp automatically opens and closes once
memo-0F
(practice operation).
*KE-432B only.
48
POWER
y
R E S E T
w
T E S T
e
BOBBIN.WIND
Motion when set to ON
KE-430B, 431B, 432B, 433B
PROGRAM NO.
P P1 P2
X - SCALE
P3 P4
Y - SCALE
SPEED
COUNTER
S E L E C T
q
r
t
0588Q