Installation; Power Table - Brother KE-430B Instruction Manual

3. INSTALLATION

Machine installation should only be carried
out by a qualified technician.
Contact your Brother dealer or a qualified
electrician for any electrical work that may
need to be done.
The sewing machine head weighs more than
52 kg. The installation should be carried out
by two or more people.
Do not connect the power cord until installa-
tion is complete, otherwise the machine may
operate if the foot switch is depressed by mis-
take, which could result in injury.
Hold the machine head with both hands when
tilting it back or returning it to its original posi-
tion. Furthermore, after tilting back the ma-
chine head, do not push the face plate side
or the pulley side from above, as this could
cause the machine head to topple over, which
may result in personal injury or damage to
the machine.

3-1. Power table

Use the power table which has been specially
•
designed for each sewing machines.
* If using a commercially-available table, process
it as shown in the illustration below.
NOTE:
The thickness of the table should be at least 40 mm, and it should be strong enough to bear the weight and vibration of
the sewing machine.
If the distance A between the insides of the legs is less than 740 mm, move the control box installation position to the
left (B = 247 mm).
Check that the control box is at least 10 mm away from the leg. If the control box and leg are touching, it could cause the
sewing machine to operate incorrectly.
KE-430B
KE-432B
KE-433B
CAUTION
All cords should be secured at least 25 mm
away from any moving parts. Furthermore,
do not excessively bend the cable or se-
cure it too firmly staples, otherwise there is
the danger that fire or electric shocks could
occur.
Be sure to connect the ground. If the ground
connection is not secure, you run the risk
of receiving a serious electric shock, and
problems with correct operation may also
occur.
Install the belt covers to the machine head
and motor.
Table/ legs
assembly
Control box
2- 38
Counterbore
depth 23
Section a-a
depth 5
KE-430B, 431B, 432B, 433B
Model
KE-430B, 432B, 433B
KE-431B
Operation
panel cord
hole
b
3. INSTALLATION
Model code
127-V30-50001
127-V31-50001
0439Q
7