Ignition Lock; Starting Engine - Skoda Yeti Owner's Manual

Skoda car
Hide thumbs Also See for Yeti:
Table of Contents

Advertisement

Ignition lock

ä
First read and observe the introductory information and safety warn-
ings
on page 97.
Petrol engines
- ignition switched off, engine off, the steering can be locked.
1
- ignition switched on
2
3
- start engine
Diesel engines
- interruption of fuel supply, ignition switched off, engine switched off, the
1
steering can be locked.
- heating glow plugs on, ignition switched on
2
- start engine
3
To lock the steering, with the ignition key withdrawn, turn the steering wheel
until the steering locking pin engages audibly.
If the steering is locked and the key cannot or can only be turned with difficulty
into the position
, move the steering wheel back and forth and the steering
2
lock will unlock.

Starting engine

ä
First read and observe the introductory information and safety warn-
ings
on page 97.
Fig. 94
Positions of the vehicle key in
the ignition lock
Vehicles with a diesel engine are equipped with a glow plug system. The pre-
glow indicator light
comes on after the ignition has been switched on. The en-
gine should be started immediately after the preglow indicator light goes out.
You should not switch on any major electrical components during the heating
period otherwise the vehicle battery will be drained unnecessarily.
Procedure for starting the engine
Before starting the engine, place the gearshift lever into neutral or place the se-
lector lever in the position P or N and firmly put on the handbrake.
Fully depress and hold the clutch pedal, switch on the ignition
start
- do not operate the accelerator. Depress the clutch pedal until the en-
3
gine starts.
Let go of the key as soon as the engine starts. After letting go, the vehicle key
will return to position
.
2
If the engine does not start within 10 seconds, abort the start-up process and
turn the key to position
. Repeat the start-up process after approx. half a mi-
1
nute.
Release the handbrake before starting off.
The engine will not start if the clutch pedal is not depressed.
The following is displayed in the information display:
Depress clutch to start!
The following is shown in the information display of the information cluster:
CLUTCH
Switching the engine off
ä
First read and observe the introductory information and safety warn-
ings
on page 97.
Switch off the engine by turning the ignition key into position
» Fig. 94
and
2
» Fig.
94.
1
99
Starting-off and Driving

Advertisement

Table of Contents
loading

Table of Contents