Storing exterior mirror setting for reversing
›
Switch on the ignition.
›
Press the required memory button
›
Move the rotary knob for the exterior mirror control into position
›
Engage reverse gear.
›
Move the right exterior mirror into the desired position
›
Take the vehicle out of gear. The set position of the exterior mirror is stored.
Emergency Off
The setting process can be interrupted at any time if necessary, by pressing any
button on the driver's seat.
Note
For safety reasons, it is not possible to store this position if the inclination angle
■
of the seat backrest is more than 102° in relation to the seat cushion.
Each new setting stored with the same button erases the previous setting.
■
Each time new seat and exterior mirror settings for forward travel are saved,
■
the individual setting for the right exterior mirror for reverse travel must also be
saved again.
Assigning the remote control key to the memory buttons
ä
First read and observe the introductory information and safety warn-
ings
on page 60.
The remote control key must be assigned to the memory button to be able to re-
trieve the settings that are stored in the memory function via the remote control
key.
Once the settings for the seat and exterior mirrors are saved
setting, you have 10 seconds to assign the radio remote control to the appropri-
ate memory button.
›
Withdraw the ignition key.
›
Press the button
on the remote control key. After the successful assign-
ment, the turn signal lights flash and an audible signal will sound as a confirma-
tion. The setting is stored with the memory button which you have selected.
.
B
» page
» page
58.
» page
62, Storing
Note
If the remote control key is assigned to a memory button, which has already
■
58.
been assigned to a radio remote control, the old assignment is replaced by the
new assignment.
If necessary, an additional remote control key can be purchased from a ŠKODA
■
Service Partner. This remote control key can then be assigned to a different mem-
ory button.
Retrieving the seat and exterior mirror settings
ä
First read and observe the introductory information and safety warn-
ings
on page 60.
Retrieving settings via the memory button
›
One-touch automatic memory: briefly press the desired memory button
» Fig.
44. The seat and exterior mirror are moved automatically into the stor-
B
ed positions (this applies only if the ignition is switched on and the speed is less
than 5 km/h).
›
Memory buttons: press and hold the desired memory button
and the exterior mirrors are moved into the stored positions.
Retrieving settings via the remote control key
›
If the driver's door is closed and the ignition is switched off, briefly press the
button
on the remote control key and open the driver's door.
The seat and exterior mirrors now move automatically into the stored positions.
Retrieving setting of exterior mirror for reversing
›
Turn the rotary knob for the exterior mirror setting into the position
before engaging the reverse gear.
›
Engage reverse gear.
The mirror returns into its initial position, after the rotary knob is moved out of
the position and put into another position or if the speed is more than 15 km/h.
Emergency Off
The setting process for the seats and exterior mirrors can be interrupted if neces-
sary, by pressing any button on the driver's seat.
until the seat
B
» page 58
63
Seats and Stowage