Removing and installing the tail light
›
Unscrew the light using the Torx key from the car tool kit. The shorter side of
the wrench is used for loosening the screws
screwing them out completely.
›
Grip the light in the upper and lower area and move backwards somewhat.
›
Disconnect the plug connection by pressing the catches in direction of arrow
» Fig. 173
and by pulling them in direction of arrow
2
›
Unscrew the securing screw
» Fig. 174
A
press the three catches in direction of arrow. Remove the plastic lamp holder.
›
When reinstalling, insert the plastic lamp holder into the tail light until the
catches audibly engage and insert the securing screw
›
Reconnect the plug connection and put the light into the original position.
›
Screw the light with the screws
Replacing the bulbs on the tail light
›
To replace the lamp
,
,
or
1
2
3
wise as far as it goes and remove it from the housing or remove the lamp
from the socket.
›
Replace the lamp, insert the socket with the bulb into the housing and insert/
turn in a clockwise direction as far as it goes.
Licence plate light
ä
First read and observe the introductory information and safety warn-
ings
on page 209.
›
Unscrew the glass cover of the light
›
Remove the faulty bulb from the holder and insert a new one.
›
Re-insert the glass cover of the light and press it down to the stop - ensure
that the glass cover is installed correctly.
›
Screw the glass cover of the light into place.
212
Do-it-yourself
» Fig. 173
and the longer side for
1
.
3
with the aid of the Torx wrench and
with the Torx key.
A
» Fig. 173
into place.
1
» Fig. 174
turn the lamp socket anti- clock-
4
Fig. 175
Luggage compartment door Li-
cence plate light
» Fig.
175.
5